www.fmiproducts.com
125204-01C
20
Lava Rock and Ember Material
1. For all models, place lava rock along sides
and front of firebox bottom in areas that
are visible. It is not necessary to use all
lava rock provided.
NOTICE: Do not put lava rock
on or under burner. Placing
lava rock on burner could cause
performance problems.
2. Pull ember material apart into pieces no
larger than a dime. Place loosely and
directly onto exposed section of front
burner and along space between burner
and grate prongs. These will create glow-
ing ember appearance as flame touches
ember material. Do not block air slots by
using too much ember material in one
area. It is not necessary to use all ember
material provided.
3. When lava rock and ember material are
in place, close and latch glass door and
secure louvers in place.
WARNING: The glass door
must be securely in place before
operating fireplace. Do not oper
-
ate fireplace if glass is missing
or broken.
DECORATIVE FACING
Any noncombustible material may be used as
facing (glass, tile, brick, etc.) as long as the
proper clearances are observed (see
Clear-
ances to Combustibles
, page 6). Louvered
openings must not be obstructed and upper
and lower panels must remain accessible for
service. Use only heat-resistant, noncom-
bustible mortar or adhesive when securing
decorative facing materials.
INSTALLATION
Continued
FACE EXTENSION
Model CD32M-LS comes equipped with a
front face extension. Front face extension
would add 3
1
/
2
" to width and 3/4" to height of
fireplace face.
An optional face extension, part number
FE-32M, is also available. When added to
the CD32M-LS or CD32MB-LS, it increases
the metal face area to the same framing
dimensions as the CD36M-LS gas, fireplace.
To install face extension:
1. Remove existing screws from front face
assembly as shown in Figure 34.
2. Align holes on top face extension with
holes on top side of front face assembly
and secure with screws previously re-
moved (see Figure 34).
3. Align holes on right face extension with
holes on right side of front face assembly
and secure with screws previously re-
moved (see Figure 34). Do the same for
left side.
4. Secure top face extension with left and
right face extensions with two sheet metal
screws (see Figure 34).
Figure 34 - Front Face Extension
Side Face
Extensions
Top Face
Extension
f i r e - p a r t s . c o m