www.fmiproducts.com
125204-01C
19
INSTALLATION
Continued
3. Place log #3 (crossover log) onto front log.
Make sure it is seated properly on surface
of rear log and pin on front log as shown
in Figure 31.
1
Figure 29 - Installing Log No. 1
Figure 30 - Installing Log No. 2
3
Figure 31 - Installing Log No. 3
INSTALLING LOGS, LAVA ROCK
AND GLOWING EMBERS
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with fireplace.
Open louvers, remove screen, unlock door
latches, and open glass door. See Removing
Glass Panel, steps 1 to 3, page 17. Install
logs according to instructions for fireplace
model numbers.
1. Find and place log #1 (rear log). The log
has a flat bottom with a slit cut into it to
sit over the grate flap, (see Figure 29).
2. Rest log #2 (front log) on pins on front part
of grate (see Figure 30).
4. Place log #4 (right log) onto the landing on
right side of front log as shown in Figure 32.
4
Figure 32 - Installing Log No. 4
5. Place log #5 (base log) onto front left part
of grate making sure log fits over metal pin
of grate. See Figure 33.
6. Place log #6 (left log) onto pin on left side
of front log, the rear part of log rests over
the log no. 1 (See Figure 33).
5
6
Figure 33 - Installing Logs No. 5 and No. 6
Grate Flap
Grate
Slit Cut
Underneath
Log
Log
Landing
Metal
Pins
Rear Log
Metal
Pin
Rear Log
Front Log
Front Log
2
Grate
Metal
Pins
f i r e - p a r t s . c o m