Fluke CableAnalyzer DSX-5000, Техническое справочное руководство, Страница: 573 / 700

Chapter 17: Use Projects
Tutorial: How to Use a Project for Tests with OptiFiber Pro and CertiFiber Pro
537
Step 1: Select a Project
If the correct project name does not show on the home screen,
tap the
PROJECT
panel, tap
CHANGE PROJECT
, tap the name of a
project, then tap
DONE
.
Step 2: Select an OTDR Test
On the home screen, tap the test type panel, on the
CHANGE
TEST
screen (Figure 201), tap the
Auto OTDR
test you made, then
tap
USE SELECTED
.
If the active ID set was not made for fiber media, the tester shows
a warning. When you tap
OK
, the tester shows the
CHANGE
CABLE IDs
screen, where you can select the correct ID set.
Step 3: Select the Correct ID and Fiber End if Necessary
The
Next ID
panel on the home screen shows the ID and fiber end
that the tester will use the next time you save results. If the panel
does not show the
Next ID
as 1A and
End 1
, select those settings:
To select a different ID set or fiber end
Tap the
Next ID
panel.
 To select a different ID set, tap
CHANGE CABLE IDs
, tap the
correct ID set, then tap
USE SELECTED
.
 To select a different fiber end, tap the
End 1
/
End 2
control at
the top of the
CHANGE CABLE IDs
screen to make it show the
correct end.
Step 4: Do OTDR Tests on End 1 of the Link
4-1
Clean and inspect all fiber connectors.
4-2.
Connect the launch cord to the tester and to
End 1
of fiber
1A. Connect the tail cord to the other end of fiber 1A.