Fluke A3003 FC, Руководство по калибровке

Страница: 6 / 24

a3003 FC/a3004 FC
Calibration Manual
2
Safety Information
A Warning identifies hazardous conditions and procedures that are dangerous to the user. A Caution identifies
conditions and procedures that can cause damage to the Product or the equipment under test.
XW
Warning
To prevent possible electrical shock, fire, or personal injury:

Carefully read all instructions.

Use the Product only as specified, or the protection supplied by the Product can
be compromised.

Limit operation to the specified measurement category, voltage, or amperage
ratings.

Do not touch voltages >30 V ac rms, 42 V ac peak, or 60 V dc.

Do not use the Product around explosive gas, vapor, or in damp or wet
environments.

Do not use the Product if it is altered or damaged.

Disable the Product if it is damaged.

Do not use the Product if it operates incorrectly.

The battery door must be closed and locked before you operate the Product.

Replace the batteries when the low battery indicator shows to prevent incorrect
measurements.

Have an approved technician repair the Product.

Use only specified replacement parts.

Comply with local and national safety codes. Use personal protective
equipment (approved rubber gloves, face protection, and flame-resistant
clothes) to prevent shock and arc blast injury where hazardous live conductors
are exposed.

Do not work alone.

Before each use, examine the Product. Look for cracks or missing pieces of the
clamp housing or output cable insulation. Also look for loose or weakened
components. Carefully examine the insulation around the jaws.

De-energize the circuit or wear personal protective equipment in compliance
with local requirements before you apply or remove the clamp.

Do not operate the Product with covers removed or the case open. Hazardous
voltage exposure is possible.

Remove the input signals before you clean the Product.

Use only the correct measurement category (CAT) for measurement.

Do not measure current if the wear indicator of cable shows.

Hold the clamp behind the tactile barrier.

Do not use the Product to measure ac current.

Do not use the Product to measure dc mA in circuits carrying more than 300 V
CAT II

Do not use the Product near strong magnetic fields.