FLIR intelliRock III, Инструкция по эксплуатации, Страница: 45 / 69

45
intelliRock technical support:
Visit www.flir.com/support or call (866) 276-8369, 9am - 5pm, EST
delete it from the cloud, but not from the logger.
From the project editing screen, you can also add a new pour to the project, or to choose a de-
fault calibration mix curve to use.
Reviewing Project Data
From the intelliRock cloud home screen, click the “Projects” button to review data. The projects
home screen, as shown in Figure 6.4, will appear. For any project, view the associated data by
checking the box next to any of the logger locations presented in the list. Figure 6.8 shows the
project home screen with one logger location checkbox selected.
Figure 6.8: Reviewing temperature data for a single logger location.
The temperature graph will initially display when one or more logger locations are selected, as
indicated by the blue, highlighted tab just above the graph. To see a different view of the data,
click on a different tab to view a strength graph, the logger data, or any thermal images.
To view the strength graph for one or more logger locations, first select the “Strength Graph”
tab, and then select a calibration mix from the “Choose Calibration” pull-down list located just
below the tabs. Consult with the project engineer to determine which calibration is the proper
one to use. If no calibration mix curves are available, refer to the “Entering New Calibrations”
section of this guide for instructions on uploading calibration mix curves. After choosing a cali-
bration, a graph similar to the one shown in Figure 6.9 will appear.