FLIR intelliRock III, Инструкция по эксплуатации, Страница: 26 / 69

26
intelliRock® III– Operating Instructions Guide
To select and associate a calibration curve on the reader with a logger that is connected to the
reader, press the F2 to select “Mix” from the screen shown in figure 4.9. Press F2 repeatedly to
cycle through all available calibration curves on the reader. After pausing when the desired cal-
ibration curve is selected, the reader screen will update the PSI field, as shown in Figure 4.12.
Figure 4.12: Logger data screen showing PSI data for a selected calibration mix.
Other functions available from the logger data screen shown in Figure 4.12 are:
• Logger (F1): transfer logger data to the reader. Instructions on doing this are covered in
the next section.
• Mix (F2): as described, associate a calibration curve with the connected logger to get a
PSI reading.
• Refresh (F4): refresh the display with the most current logger data.
• Setup (F5): access the logger setup menu, as described in the previous section of this
guide.
Even though the summary data is shown for review on the screen depicted in Figure 4.12, the
data has not been transferred to the intelliRock III reader. Refer to the next section for instruc-
tions on transferring and viewing detailed logger data.
Downloading Logger Data to the Reader
After reviewing a logger’s data, the user may wish to transfer that data to the intelliRock III
reader. To do so, from the screen shown in Figure 4.12, press the F1 key for “Logger” which will
start the data transfer. The “Data ready to be read” message shown in Figure 4.13 will appear
on the screen.
Figure 4.13: Data from the connected logger is ready for review and transfer to the reader.