FLIR Detection
4. FLIR identiFINDER R300 Modes
Best Range
Current Count Rate
ent Count Rate
ent Count Rate
Advice
Figure 92.
Identi ication Mode: Count rate too low for best results
Best Range
Current Count Rate
Advice
Figure 93.
Identi ication Mode: Count rate too high for best results
The acquisition of data stops after the duration or count criterion (
6.4
, p.
116
) is met or when you
Exit
. The FLIR identiFINDER R300 applies the identi ication algorithm and saves and displays the
result (Figure
95
, p.
92
and Figure
96
, p.
93
). If nuclides were identi ied, the results are saved. The
reference number of the saved record is shown so you can refer to it for further processing.
You can specify whether con idence, usage, or severity are shown, see
6.4
, p.
116
.
Nuclides the identi ication algorithm did not recognize or those recognized but having their
visibility suppressed (see
, p.
) are reported as “Unknown”.
Settings and Commands
Dose
Switch to Dose Rate mode (see
4.1
, p.
86
).
identiFINDER
®
R300/en/2014.4(13623)/Feb2015
91