Flexim FLUXUS F60 Series, Руководство по эксплуатации, Страница: 40 / 244

6 Installation
6.2 Transducers
FLUXUS F60*
2017-10-16, UMFLUXUSF60xV5-0EN
40
6.2.2 Installation of the transducers
6.2.2.1 Orientation of the transducers and determination of the transducer
distance
Observe the orientation of the transducers. If the transducers have been mounted prop-
erly, the engravings on the transducers form an arrow, see Fig. 6.7. The transducer ca-
bles show in opposite directions.
The transducer distance measured between the inner edges of the transducers.
6.2.2.2 Installation of transducers with fastening shoes and chains
• Insert the transducers into the fastening shoes. Turn the screw on top of the fastening
shoes by 90° to engage and lock its end in the groove on top of the inserted transducer.
• Insert the ruler into the lateral slot of the fastening shoes. Adjust the displayed transduc-
er distance, see section 9.3. Fix the transducers with the plastic screws on the trans-
ducer cable side of the fastening shoes.
• Place the fastening shoes/ruler assembly on the pipe at the measuring point. Insert the
last ball into the slot on the upper side of one of the fastening shoe.
• Place the chain around the pipe.
• Tighten the chain and insert it into the other slot of the fastening shoe.
Notice!
Handle the transducer cable with care. Avoid sharp bends or kinks, especially at
simultaneous strain.
Fig. 6.7: Orientation of the transducers and transducer distance
a – transducer distance
a