Fischer Panda Panda AGT 6000, Руководство пользователя

Страница: 154 / 192

Tables
Seite/Page 154 - Kaptitel/Chapter 9: Tables 9.12.14
9.1.12 Generator must be shut off immediately if
9.1.13 Troubleshooting VCS system
9.2 Technical data engine
Cause Solution
- motor rpm suddenly rises or drops
- unusual noise comes from genset
- exhaust colour suddenly becomes dark
- motor overheats
- oil pressure drops, oil light suddenly flashes Refer to respective section of manual and if necessary, have repaired by
Kubota-Service, or Panda representative.
Cause Solution
Actuator does not move. Check voltage supply and wire connections to actuator.
Motor connected?
Check connection to VCS.
Actuator sets throttle too high or too low. Check that the wires to the actuator are connected properly (±).
Check connection to VCS.
If the VCS electronics are faulty, the generator can still run by over-riding the system. To override the VCS, disconnect the plug and jumper the
contacts.
Loosen the connecting rods motor from the injection pump regulator and turn screw to a max. voltage of 33 V.
Model Kubota D1105
Type D1105
Governor VCS
Automatic start booster yes
Cylinder 3
Bore 78 mm
Stroke 78,4 mm
Stroke volume 1123 cm³
Max. power (DIN 6271-NB) at 3000rpm 18,7 kW
Rated speed 3000 rpm
Idle running speed ² 2900 rpm
Valve clearance (engine cold) 0,2 mm
Cylinder head nut torque 68 Nm
Compression ratio 22:1
Lubrication oil capacity 5,1 l
Fuel consumption ³ approx. 1,7-4,5l
Oil consumption max. 1% of fuel consumption
Oil specification API CF
Cooling water requirement for seawater cir-
cuit (Marine generators only) 28-40l/min
Permissible max. permanent tilt of engine a) 25° crosswise to the longitudinal axis
b) 20° in longitudinal direction
Recommend starter battery size 12V 65Ah equivalent
Recommend cable cross size starter battery
cable
Length 4 meter max.
25mm²
Max. exhaust back pressure 10,7 kPa
107 Millibar