Fischer Panda Panda AGT 6000, Руководство пользователя

Страница: 118 / 192

Maintenance Instructions
Seite/Page 118 - Kaptitel/Chapter 7: Maintenance Instructions 9.12.14
7.6 Oil circuit maintenance
The first oil change is to be accomplished after a period of operation from 35 to 50 hours. Afterwards the oil is to be
changed after 100 hours. For this the oil SAE30 for temperatures over 20 °C and SAE20 for temperatures between
5 °C and 20 °C is to be used. At temperatures under 5°C oil of the viscosity SAE10W or 10W-30 is prescribed.
Type and amount of required oil see:
See section , “The AGT-DC system consists of the AGT generator in conjunction with the rectifier unit named on the
type plate and is only allowed in this combination!,” on page 155.
7.7 Checking oil-level
You require:
paper towels / cloth for the oil dipstick
The generator must be placed at level.
• with vehicular generators: Place the vehicle on a levelled surface.
• with PSC generators: Place the generator on a levelled surface.
• with marine generators: Measure the oil-level when the ship is not lop-sided.
Run the generator for about 10 minutes to ensure that the engine is warm. Wait for 3 minutes, so the oil can flow
back into the oil pan.
Caution: Burn hazard! Generator and coolant can be hot during and after
operating.
Wear personal protective equipment. (Gloves, protective
goggles, protective clothing and safety shoes)
• Assure generator against accidental start.
• Open the generator casing.
• Pull the oil dipstick out of the check rail.
• Clean oil dipstick.
• Put the oil dipstick back into the check rail and wait for 10 seconds.
• Pull the oil dipstick out of the check rail and read off the oil-level at the lower end of the stick.
Fig. 7.7-1: Oil dipstick - Sample Oil dipstick
The oil-level is to be checked by means of the oil dipstick.
The prescribed filling level must not cross the „Max“-mark.
We recommend an oil-level of 2/3.
Sample picture
2/3 Suggestion
Oil Max.
Oil Min.