Fischer Panda Panda AGT 6000, Руководство пользователя

Страница: 148 / 192

Generator Failure
Seite/Page 148 - Kaptitel/Chapter 8: Generator Failure 9.12.14
8.4.3 Stop solenoid
Fig. 8.4.3-1: Stop solenoid Stop solenoid for engine stop
8.4.4 Failure Bypass Switch
The start-failure bypass switch enables an immediate restart facility of the generator, should it cut out, even if this
was caused by over-heating. There is normally a requirement to wait until the motor has cooled down to the correct
temperature. This can last for several hours in certain circumstances, since the generator is enclosed in a sound-
insulated casing, which prevents heat loss.
Fig. 8.4.4-1: Failure bypass switch Failure bypass switch
This period can be reduced by pushing the button on the front of the generator. The generator can be started by
means of the remote control as long as the button is depressed. The switch/button bypasses any faults allowing the
generator to run.
Before depressing the button, a manual check of the oil dip stick must be carried out to determine whether the
generator has sufficient oil, as it is possible that the oil pressure switch causes the generator to cut out. If it has been
ascertained that the reason for the motor cutting out is overheating and not lack of oil, the generator can be run for
several minutes without load, so that the motor is cooled by the circulating coolant.
Note: If the temperature is the reason for the generator cutting
out when it is running under load, then an immediate
check must be made to determine the cause. It could be
a fault with the cooling system, one of the fans, the air-
intake or a fault with the external cooling system.