Fischer Panda Panda 25i PMS, Руководство пользователя

Страница: 183 / 216

Safety instructions for the Panda iControl2
20.7.15 Kapitel/Chapter 11: Safety instructions for the Panda iControl2 - Seite/Page 183
11. Safety instructions for the Panda iControl2
11.1 Personnel
The settings described here can be performed by the operator unless highlighted differently.
The installation should be implemented by specially trained technical personnel or by authorised workshops (Fischer
Panda Service Points), only.
11.2 Safety instructions
NOTE: Ensure compliance with the safety instructions in the
Fischer Panda genset manual.
If these instructions are not on hand, they can be requested
from Fischer Panda GmbH, 33104 Paderborn, Germany.
WARNING: Automatic start-up An external signal may trigger an automatic start-up.
WARNING: The generator must not be operated with the cover
removed.
If the generator is being installed without a sound insulation
capsule, it must be ensured that all rotating parts (belt pulley,
belts etc.) are covered and protected so that there is no
danger to life and body!
If a sound insulation capsule will be produced at the place of
installation, then well-placed signs must show that the
generator can only be switched on with the capsule closed.
All service, maintenance, or repair work may only be carried
out when the unit is not running.
WARNING: Electric voltage Electric voltage - DANGER TO LIFE!
Electric voltages of more than 48V are potentially lethal in
any situation. The rules of the respective regional authority
must be adhered to for installation and maintenance.
For safety reasons, only an electrician may carry out the
installation of the electrical connections of the generator.
WARNING: Disconnect battery before working on the generator
The battery must always be disconnected (first the negative
terminal, then the positive terminal) if work on the generator
or electrical system is to be carried out, so that the generator
cannot be unintentionally started.
This applies in particular to systems with an automatic start-
up function. The automatic start-up function shall be
deactivated before starting work.