Fischer Panda Panda 25i PMS, Руководство пользователя

Страница: 167 / 216

Inverter Panda PMGi 25
20.7.15 Kapitel/Chapter 10: Inverter Panda PMGi 25 - Seite/Page 167
10.11Installation of the PMGi
The PMGi must be mounted vertical, with the electrical connection down. So you can read the writing on the PMGi.
The surface where the PMGi is mounted should be smoothed and support the heat transfer. The Air holes and Air
grille must be not covered and enough cooling air must be pleasant at any time for the PMGi.
To mount the PMGi use the four fixing holes diameter 6,5mm.
Note! See the safety instruction in your Generator and iControl
Manual.
The rules of the respective regional authority must be adhered to. Only an electrician may carry out installation of the
electrical connections for safety reasons.
10.11.1 Cooling water connection schema - Vehicle Generator
10.11.1.1 Integration of a watercooled PMGi inverter into the cooling system.
The watercooled PMGi needs a seperate cooling circle. Normal a small radiator net is attached to the bigger
Generator Radiator. The circle has its own electrical water pump, which is powered by the generator.