Fischer Panda 5000i PVK-U, Руководство пользователя

Страница: 135 / 174

General operation
30.10.12 Chapter 10: General operation - Page 135
Fig. 10.1.3.3-1: Default display screen in override mode
10.1.3.4 Operation mode
Operation mode signifies the operating mode in which the generator is running and all operating data are within their
normal range. The status field of the default display screen shows "RUNNING".
Fig. 10.1.3.4-1: Default display screen in operation mode In operation mode, the electrical load is given on the right hand
side of the default display screen and in the inverter screen as
a bar graph. The bar graph merely provides a guide value for
the load of the generator and gives the values as a percentage.
Fig. 10.1.3.4-2: Inverter screen in operation mode With the i-series generators, there is an additional screen in
operation mode for the inverter data. This screen provides the
current inverter output voltage and the inverter temperature.
You can access the inverter screen by actuating the cursor-up
button while in operation mode.
10.1.3.5 Stop mode
By actuating the Start/Stop button in operation mode, i.e., while the generator is running, you will stop the generator.
After stopping the generator, the system will return to stand-by mode. The display status field reads "STOPPING".
Note: Manual start in autostart mode
If the generator is manually started up and stopped while in
automatic start-up mode, it will switch to stand-by mode for
safety reasons.
If necessary, the autostart mode must be reactivated.
10.1.3.6 Autostart mode
The Panda iControl2 panel is equipped with an autostart function. A jumper between pin 6 (UBAT) and pin 7
(USTARTI of the Phoenix jack of the control panel starts up the generator with a delay of 5 seconds when the
autostart function is active. Removing the jumper will stop the generator - also with a delay of 5 seconds.
To activate the autostart function, you must first check the "Autostart" flag in the set-up menu. To activate the
autostart function, read See “Activating/deactivating the autostart function ("Autostart")” on Page 139.