First Degree Fitness Fluid FR S-350, Руководство пользователя

Страница: 18 / 24

Idle wheel
Step 8 . Once the bungee cord is fitted
properly and seated flush inside the
belt/bungee pulley, thread the rower belt
back on to the belt bungee pulley until
the rower handle is at its furthest point
forward. Then, remove the bungee
wraps from the belt/bungee pulley com-
pletely. At this point, make one clock-
wise wrap of the bungee cord on the
belt bungee pulley as shown right.
Then, follow the illustrations below to
wrap the bungee cords around the
bungee pulleys.
Changing the bungee cord
Step 7 . Feed the replacement bungee through the
sprocket hole and belt bungee pulley as shown.
Holding the Idle wheel with one hand as pictured will
prevent the belt/bungee and sprocket holes from
moving out of alignment when threading the bungee
cord. If the two holes move out of alignment while
threading the bungee cord stop, remove the bungee
cord, realign the holes and try again.
Caution
Forcing the bungee cord with the belt/bungee pulley
and sprocket not aligned will result in damage to the
bungee cord!
Wrapping the bungee cord around the bungee pulleys.
Begin with the lower right
bungee pulley, taking care
to keep the bungee cord
behind the frame tensioning
bolt as pictured. Next, thread the bungee
around the lower left rear
bungee pulley. Then, thread the bungee
around the upper left rear
bungee pulley. Next, thread the
bungee around the
lower left front bungee
pulley, and then up to
the upper left front
bungee pulley, finish-
ing at the tie off point
located at the left lower
section of the frame.
(See step 2)
Tip: Keeping the bungee cord under slight tension will help prevent the
cord from slipping off the bungee pulleys while wrapping.
Shown left: The
Rower belt is properly
rewound onto the
Belt/Bungee pulley.
Note also the correct
position for the
bungee cord prior to
rewinding the bungee
cord around the belt
pulleys as shown
below.
Rower
belt
Bungee cord