First Degree Fitness Fluid FR S-350, Руководство пользователя

Страница: 15 / 24

Fault Probable Cause Solution
Water changes color or becomes cloudy. Rower is in direct sunlight or has not had
water treatment.
Change rower location to reduce direct expo-
sure to sunlight. Add water treatment and blue
dye or change tank water as directed in the
water treatment section of this manual.
Rower belt slipping off belt/ bungee pulley. Bungee not under enough tension.
Tighten bungee cord following the instructions
in the Replacing the bungee/shock cord section
of this manual.
Front of rower lifts slightly during vigorous
rowing. Lower rear frame leveler too high.
Refer to the Fine Tuning section of this manual
Excessive frame flex during hard rowing. Lower rear frame leveler too low. Refer to the Fine Tuning section of this manual.
Computer screen illuminates, but does not
register when rowing. Loose or failed connection. Check that the computer lead is connected
properly. If it is connected then contact your
local service center.
Excessive Chain noise.
Loose or dry chain.
Loosen tank bolts slightly and then use the
tank tensioning bolt to tighten chain. Lubricate
with supplied 20-weight oil. Use drop cloth un-
der frame. Refer to the Maintenance page,
chain tension and lubrication for details.
The S-350 computer does not illuminate after
battery installation. Batteries installed incorrectly or need re-
placing.
Reinstall batteries in correct position and try
again. If the LCD screen fails to illuminate, try
rotating the batteries slightly in the computer. If
this fails, contact your local service center.
Troubleshooting Guide