First Degree Fitness Fluid FR S-350, Руководство пользователя

Страница: 16 / 24

Step 1
Lower right pulley
Belt Removal
1. To remove the rower belt, simply continue past the normal rowing position rearward until
the belt detaches from the belt/bungee pulley.
Replacing the belt
2. First remove the rear PVC cover at the rear of the machine. Then remove metal inspection plate which is located on
the right side of the upper frame to access the belt/bungee pulley.
3. Detach the bungee cord at bottom left of frame.
3. Feed the belt through the top belt pulley with the velcro facing down .
Then feed the belt across the idle wheel as shown (upper left).
4. Feed the belt onto the belt/bungee pulley slowly clockwise until the rower handle is right to the computer mount. You
can check your progress by looking through the inspection plate to make sure the belt is wrapping smoothly as
shown left.
Note: The bungee cord will need to be rewrapped around the belt bungee pulley and bungee wheels correctly once
the rower belt is position.
Warning: Do not attempt to operate the machine until the bungee cord has been properly re-wrapped.
5. Unwrap the bungee cord from the belt bungee pulley until you see the placement hole in
the belt/bungee pulley. Then, make one clockwise wrap as shown (lower left) and feed the bungee onto
the bungee pulleys following the steps below:
Step 2
Lower left rear pulley
Step 3
Upper rear pulley
Step 4
Lower rear to up-
per rear pulley
Finish by tying off at the
bungee attachment point
at the bottom left of the
inner frame. Approx
5cm of bungee fed
through the attachment
point should provide the
proper tension.
Tip: Keeping the
bungee under tension
while wrapping will help
prevent the bungee from
slipping off the bungee
pulleys .
Proper belt feed through belt pulley
and around idle wheel
Beginning the belt wrap on the
belt bungee pulley
Proper bungee position prior to
reinstalling around the bungee
pulleys as shown right.
Changing the Rower belt