Fireye BurnerLogiX BLL510, Руководство пользователя

Страница: 14 / 80

14
®
FIGURE 3.
7.
Although the unit can withstand substantial vibration without damage or significant output
effects, it is good practice to mount the pressure sensor where there is minimum vibration.
8.
A steam trap (siphon loop) must be connected between the boiler and the pressure sensor to pre-
vent boiler scale and corrosive vapors from affecting the pressure sensor element.
9.
Make all pipe connections in accordance with approved standards.
10.
When tightening the sensor, apply a wrench to the hex flats located just above the pressure fit-
ting. DO NOT tighten by using a pipe wrench on the housing. Do not tighten the pressure sensor
by hand.
.
MOUNTING TEMPERATURE SENSORS
The immersion style temperature sensors have a ½" NPT mounting for the 2", 4", and 8" thermowell
probes, and a ½" conduit fitting for electrical connections.
HOT WATER, STANDBY WATER TEMPERATURE
Note: Refer to Figure 3
1.
Disconnect power to the boiler controller so the boiler cannot sequence during installation of the
hot water temperature sensor.
2.
The thermowell must be mounted where it is always exposed to the circulation of the hot water.
3.
If the water system is full, drain the system below the point where the thermowell will be
installed.
4.
Tap an appropriate size fitting. (2", 4" and 8" thermowell have ½" NPT fitting).
5.
Insert the appropriate thermowell (2", 4", or 8") and tighten.
6.
Fill the system to check for leakage.
STACK TEMPERATURE
1.
Use the existing well connection for the stack temperature sensor if provided by the boiler
manufacturer.
WARNING: The electro-mechanical high steam limit and/or high hot water temperature
MUST REMAIN in the 3-P running interlock circuit.
WARNING: Location of the temperature sensor to monitor boiler water temperature of a
steam boiler is critical. The sensor should be mounted where it is always exposed to the cir-
culation of the boiler water, not too close to a hot or cold inlet or steam coil. Consult the
boiler manufacturer for guidance on the sensor location