Mounting
Adjustment of the AKAS® at the first installation
correction of adjustment errors
18
5
5.7
AKAS®-II Fig. 18/1
C
possible maladjustment
AKAS® LC II M / -F
remedy
AKAS®-LC II M / -F
The beam misses the target circle of
the magentic lamina at both of the tool
tips and meets at the right hand side
of the circle.
The beam misses the target circle of
the magentic lamina at both of the tool
tips and meets at the left hand side of
the circle.
By unscrewing all M4adjustment screws
(Fig. 15/2) the support must be positioned
further away behind the bending line. i.e.
push the Fiessler holders in their slots
further to the front.
By tightening all M4adjustment screws
(Fig. 15/2) the support must be put closer
to the bending line, i.e. push the Fiessler
holders in their slots further to the front.
.
The beam hits the target circle at the
left tool end, at the right tool end the
beam edge is lower than the target cir-
cle =
case B
Fig. 18/1
The beam hits the target circle at the
left tool end, at the right tool end the
beam edge is further up than the tar-
get circle =
case C
Fig. 18/1
The beam hits the target circle at the
left tool end, and at the right tool end
the beam it hits a spot at the left out-
side of the target circle
The beam hits the target circle at the
left tool tip, and at the right tool end
the beam it hits a spot at the right,
outside of the target circle
The transmitter must be turned to the
right in the slot, i.e. on the Fiessler hol-
ders, the inclination adjustment screw
mzust be tightened.
.
The transmitter must be turned to the left
in the slot, i.e. on the Fiessler holders,
the inclination adjustment screw must be
looseend.
After unscrewing the upper left M4 adjust-
ment screws and after readjusting the
right M4 adjustment screws the transmit-
ter (Fig. 15/2) must be turned clockwise
around its longitudinal axis, i.e. at the
Fiessler holders, the swiveling is carried
out counterclockwise by loosening of the
front swiveling adjustment screw and by
tightening of the rear swiveling adjust-
ment screw
After unscrewing the upper left M4 adjust-
ment screws and after readjusting the
right M4 adjustment screws the transmit-
ter (Fig. 15/2) must be turned counter-
clockwise, i.e. at the Fiessler holders, the
swiveling is carried out counterclockwise
by loosening of the rear swiveling adjust-
Doku Nr. 995 Stand 1.12.2011 / Aui
correct transmitter adjustment
in correct transmitter adjustment
case A
case B
case C
FIESSLER
E L E K T R O N I K
