The switch is able to dispense the 230V power directly as connected load or switch a second external load.
The wirings are shown below. In both cases the two wired from the mains distribution panel are connected
to the inserts contacts N and L. Depending on whether the 230 V supply of the switch or an external power
supply is used to power the electrical load, either the 230 V supply or the external power supply has to be
connected to the insert contact I . The electrical load is then connected to the other pole of the 230 V power
supply or with the second pole of the additional power supply.
The switch can be operated locally using a switching paddle installed on the wall box. To connect the
switching paddle with the dimmer insert it has to be connected with the insert contacts S1, S2 and
Sx. Attention: There must not be mains-power connected to the insert contacts. This would
immediately lead to a destruction of the dimmer.
(c) 2016 Z-Wave Europe GmbH, Antonstr. 3, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 3
