3
Important safety information
Read this manual before attempting to install the device!
Failure to observe recommendations included in this manual
may be dangerous or cause a violation of the law. The manufacturer,
Fibar Group S.A. will not be held responsible for any loss or damage
resulting from not following the instructions of operating manual.
!
Danger of electrocution!
Dimmer 2 is designed to operate in electrical home installa-
tion. Faulty connection or use may result in fire or electric shock.
All works on the device may be performed only by a qualified and
licensed electrician. Observe national regulations.
Even when the device is turned off, voltage may be present at its ter-
minals. Any maintenance introducing changes into the configuration
of connections or the load must be always performed with disabled
fuse
General information about
the FIBARO System
FIBARO is a wireless smart home automation system, based on the
Z-Wave protocol. All of available devices can be controlled through
a computer (PC or Mac), smartphone or tablet. Devices are not only
receivers, but can also repeat the signal, increasing the Z-Wave
network’s range. It gives advantage over traditional wireless systems
that require direct link between transmitter and receiver, as a result the
construction of the building could affect network’s range negatively.
Every FIBARO network has its unique identification number (home
ID). Multiple independent networks can exist in the building without
interfering. Transmission security of FIBARO System is comparable to
wired systems.
Z-Wave technology is the leading solution in smart home automation.
There is a wide range of Z-Wave devices that are mutually
compatible, independently of manufacturer. It gives the system the
ability to evolve and expand over time. For more information visit:
www.fibaro.com.
Required overcurrent protection
Dimmer 2 must be protected with an overcurrent protection
(fuse) with a value not higher than 10A.
!
Содержание FGD-212
Страница 2: ......
