Equipment Details
92
the system will choose the most suitable
power supply and the AUTO symbol and
the symbol of the power supply chosen
by the system will both be shown on the
LCD display. Ten seconds after release of
the mode selector switch, the system will
switch off the LCD backlight.
C. Use the cooling level selector switch to
control the temperature of the refrigerator.
When you press the cooling level selector
switch, the LCD backlight will light up
and show the currently set temperature.
Every time you press the cooling level
selector switch again, you set the
refrigerator one position cooler. On
reaching the coldest temperature, the
system will start again at the warmest
temperature setting. Ten seconds after
release of the cooling level selector
switch, the system will switch off the LCD
backlight.
Powering with electricity
Powering with electricity can be selected
both by the Auto mode (only Automatic
fridges) and manually.
Auto mode
Mains voltage (230V):
This energy source will be selected if the
mains voltage is greater than 200V. This
power supply requires a continuous current
of 12V to operate the electronic control
system.
Direct current (12V) :
The SES system will select 12 V powering
only if a mains voltage (230V) is unavailable,
the vehicle engine is running and a voltage
higher than 11V is available.
If a fault occurs during electrical powering
(230V or 12V), an error message will not be
shown on the display as long as another
energy source is available. The system will
automatically switch to the available energy
source that has the highest priority.
Selecting electrical power manually
Mains voltage (230V):
The LED warns you whenever insufficient
voltage is available or if a fault occurs. If
this happens, the LED will start flashing
once per second and an error code is
shown in the LCD display
When sufficient current is available again, or
the fault has been resolved, the LED will emit
a steady blue light again.
Direct current (12V):
The LED warns you whenever your
vehicle's engine is not running, or if a
fault occurs, or if insufficient voltage is
available. If this happens, the LED will
start flashing once per second and an
error code is shown in the LCD display.
Once the engine is running, or the fault has
been resolved, or sufficient voltage is
available again, the LED will again emit a
steady blue light.
NB:
If the refrigerator has been manually set
to operate at 12V, it will not automatically
switch to another energy source when your
vehicle's engine is not running. In this case,
the refrigerator will stop cooling.
Powering with gas
Powering with gas can be selected both by
the Auto mode (only Automatic fridges) and
manually.
Warning!
- Flammable material must be kept
away from the rear of the refrigerator.
• For selection of gas type, see the
information plate inside your refrigerator.
• For the pressure regulator model, see the
information plate inside your refrigerator.
• The type of gas container and its location
must be in compliance with the most
recent regulations. Ensure that the unit is
installed in a location with good
ventilation and make sure that the
ventilation openings in the gas container
storage location remain open.
• The changing of the gas container must
be done outside in the open air and out
of reach of any possible sources of
ignition.
Содержание X2-50 Cab
