Fiat X2-50 Cab, Руководство пользователя

Страница: 81 / 124

Equipment Details
90
Once the engine is running, or the fault has
been resolved, or sufficient voltage is
available again, the main switch LED will
again emit a steady green light.
NB: If the refrigerator has been manually set
to operate at 12V, it will not automatically
switch to another energy source when your
vehicle's engine is not running. In this case,
the refrigerator will stop cooling.
Powering with gas
Powering with gas can be selected both by
the Auto mode and manually.
Warning! - Flammable material must be kept
away from the refrigerator.
• For selection of gas type, see the
information plate inside your refrigerator.
• For the pressure regulator model, see the
information plate inside your refrigerator.
• The type of gas container and its location
must be in compliance with the most
recent regulations. Ensure that the unit is
installed in a location with good
ventilation and make sure that the
ventilation openings in the gas container
storage location remain open.
• The changing of the gas container must
be done outside in the open air and out of
reach of any possible sources of ignition.
• It is prohibited to use gas to power the
refrigerator while you are driving. If a road
accident results in fire, there is a danger
of explosion.
• It is prohibited to use gas to power the
refrigerator in the vicinity of petrol
stations.
Auto mode
The system will select gas operation if:
- mains voltage (230V) is unavailable;
- the vehicle's engine is not running.
Once mains voltage (230V) is available again
or the vehicle's engine is running, the system
will switch to the available energy source
that has the highest priority. If the refrigerator
switches from 12V DC to gas operation
when it is in auto mode, the system will wait
for about 15 minutes before igniting the gas.
During this time, however, the gas indicator
lamp will come on. The delay is built in to
avoid it switching to gas operation whenever
you stop to refuel your vehicle. You can
cancel the delay by immediately switching
the refrigerator off and then on again. If the
system selects gas operation, the ignition
will be activated automatically. The gas will
flow to the burner and be lit by the electric
ignition. If the flame goes out, the gas will
immediately be lit again.
Selecting gas operation manually
If the flame cannot be lit within 30
seconds, the gas supply will stop and gas
mode will be switched off. The LED of the
main switch will turn from green to red
and flash every second.
The gas mode can be reset only if the
refrigerator is switched off. If you switch the
refrigerator on again and the gas mode is still
not working, the LED of the manual gas
mode will flash to indicate that gas is
unavailable.
Important! It is prohibited to use gas to
power the refrigerator while you are driving.
If a road accident results in a fire, there is a
danger of explosion. It is prohibited to use
gas to power the refrigerator in the vicinity of
petrol stations. If it takes longer than 15
minutes to refuel your vehicle, you should
switch the refrigerator off using the main
switch (A).
Switching off the refrigerator
• Set the main switch (A) to 0 (off).
• The refrigerator is now completely
switched off.
• Use the special storage latch on the door
locking mechanism to stop the door from
closing. This prevents unpleasant odours
and mould in the refrigerator.