Fiat X2-50 Cab, Руководство пользователя

Страница: 107 / 124

Table Storage
Tables stored in the table storage
compartment must be securely clipped into
place whilst in transit.
To avoid damage care must be taken when
removing tables from their stored position.
CARE OF LAMINATE TOPS,
TABLES, FURNITURE AND
DOORS
DO NOT use abrasives, chemically treated
cloths or aggressive detergents as these
may cause damage.
DO NOT place hot objects on laminated
surfaces i.e. tops, tables. Any temperatures
70°C and over will cause permanent
damage.
Clean worktop surfaces, furniture and door
fascias with a soft, slightly damp cloth, dry
off with a soft cloth.
SHOWER
When using the shower, always ensure that
the shower door is fully closed thus avoiding
water spray on unprotected areas.
12V READING LAMP
WARNING: 12v reading/spotlamps
generate high temperatures when in use,
the body, lens/bulb may become very
hot.
NEVER make directional adjustment in
the direction of flammable materials i.e.
curtains, nets or blinds.
OMNISTEP SLIDE-OUT STEP
OPERATION
Press the “step out” key to bring the step
out until it reaches the end of its run or
comes up against an obstacle. The step
does not come out if the the engine is
running. Press the “step in” key to take the
step back until it reaches the end of its run
or comes up against an obstacle. The step
goes back in automatically when the engine
is running. In this situation the buzzer sounds
until the step is fully closed.
MAINTENANCE
Dirt and frost can prevent the step from
operating properly. In this case the rails and
moving parts should be cleaned or
defrosted.
IN CASE OF ELECTRIC BREAK DOWN
If the step does not retract by the motor
- Remove the front plate of the step. (Fig. 1)
- Remove the connection between the
footboard and the arms (with screwdriver
and wrench S10). (Fig. 2)
- Slide out the footboard.
- Reinstall the front plate.
CURRENT DRAWN
- Working current: 5 A
- Blocking current, when fully extended or
retracted: 14 A
Equipment Details
116
Fig. 1 Front Plate
Fig. 2 Connection