171
continuous tone area is always marked
with a red arc.
FAULT INDICATION
Parking sensor faults, if any, will be
indicated by the switching on of the
symbol on the instrument panel
together with the message on the
display (see description in the "Warning
lights and messages" chapter in the
"Knowing the instrument panel"
section).
MESSAGES ON THE
DISPLAY
If the system detects a failure, a
dedicated message is shown on the
display for about 5 seconds.
If the display shows messages
requiring the front or rear sensor
cleaning, make sure that the outer
surface and the underside of the
bumper is free of dirt (e.g. snow,
mud, ice, etc.). After performing this
check, turn the ignition device in STOP
position, then turn it to the ENGINE
position and check whether the
messages are no longer displayed. If
messages are still displayed, contact a
Fiat Dealership.
GENERAL WARNINGS
49) 50)
Some conditions may influence the
performance of the Side Distance
Warning system:
reduced sensor sensitivity and a
reduction in the parking assistance
system performance could be due to
the presence of: ice, snow, mud, thick
paint, on the surface of the sensor;
the sensor may detect a non-existent
obstacle ("echo interference") due to
mechanical interference, for example
when washing the car, in rain (strong
wind), hail;
the signals sent by the sensor can
also be altered by the presence of
ultrasonic systems (e.g. pneumatic
brake systems of trucks or pneumatic
drills) near the vehicle;
the performance of the Side Distance
Warning system can be influenced
by the position of the sensors, e.g.
by changing the set-up of the car
(due to wear of shock absorbers or
suspensions), replacing the tyres with
others of different sizes, travelling with
a loaded car, installing specific set-ups
to lower the car;
the presence of stickers on the
sensors can adversely affect the
correct operation of the system.
Therefore, take care not to place
stickers on the sensors.
IMPORTANT
49)
The sensors must be clean of mud,
dirt, snow or ice in order for the system to
operate correctly. Be careful not to scratch
or damage the sensors while cleaning
them. Avoid using dry, rough or hard
cloths. The sensors should be washed
using clean water with the addition of car
shampoo if necessary. When using special
washing equipment such as high pressure
jets or steam cleaning, clean the sensors
very quickly keeping the jet more than 10
cm away.
50)
Only have the bumper repainted or
any retouches to the paintwork in the
area of the sensors carried out by a Fiat
Dealership. Incorrect paint application
could affect the operation of the parking
sensors.
Содержание New 500
