Festo DGE ZR RF Series, Инструкции по ремонту

Страница: 56 / 64

12 / 20 Festo 7Tension01_TBb_en
With position stops and distance pieces (ELGA-TB-G-…)
Note
The position stops are necessary to align the test equipment with the
toothed belt axis.
• Place the position stops for the ELGA toothed belt axis on the test equipment
and secure it using the knurled screws.
• Place the position stop bolts in the position stops as appropriate to the size
of the toothed belt axis.
• Place the appropriate distance piece for the size of the toothed belt axis on
the free side of the test equipment and secure it at the position “E” using
the 7 mm ø stop bolt.
• Place the test equipment to the left or right of the slide/piston (S.L. or S.R.)
as appropriate to the position of the distance piece (must be facing the
slide) in accordance with the table.
• Push the test equipment forwards so that the position stops on the cylinder
barrel touch the toothed belt axis.
Without position stops (EGC-…-TB-KF)
• Remove the position stops from the test equipment.
• Place the test equipment on the toothed belt axis in front of the guide rail to
the left or right of the slide in accordance with the table.
• Push the test equipment backwards so that it is touching the guide rail.
Note
The test equipment is attached to the guide rail by means of integrated
magnets.