Ferris 46764, Руководство оператора

Страница: 16 / 34

10
04
Figure 18. Install Mount Plate
A. Rear Shield F. 3/8-16 x 2-1/2” Bolt
B. 3/8-16 x 1” Bolt G. Bar Clamp
C. Mount Plate H. 3/8-16 Nylon Lock Nut
D. Mount Spacer I. 3/8-16 x 2” Bolt
E. 3/8-16 Flange Nut
C
E
E
D
Install Mount Plate
(Ferris 1000Z & IS1000Z Series and Derby Colt “T”
Series)
1. Remove the lower right-hand bolt, washer & nut
(circled) from the rear shield (A, Figure 18) and the
3/8-16 x 1-1/2” bolt (circled) from the lower right-
hand corner of the bumper (IS1000Z 52” model &
Derby Colt ZT2352T only).
2. Install the mount plate (C) using the hardware previ-
ously removed. Make sure the mount plate is
square with the bottom edge of the lower bumper.
This is critical. Tighten securely. For additional sup-
port, use a clamp to secure the bottom edge of the
mount plate to the lower bumper.
3. With a 3/8” drill bit, use the three (3) holes shown
above with bolts (B) or (I), in the mount plate as a
guide and drill through the rear shield and lower
bumper.
4. Remove the clamp and hardware securing the mount
plate to the lower bumper.
5. Install the mount plate (C) and mount spacer (D) on
the lower bumper and secure with the 3/8-16 x 1”
bolts (B) and 3/8-16 flange nuts (E) as shown.
NOTE: When installing a 2-bag system on a IS1000Z
52” model or Derby Colt ZT2352T, secure the mount
plate and spacer (C & D) with the 3/8-16 x 2” bolts (I) in
both upper holes and lower left-hand hole as shown.
Install Mount Plate
(Derby Colts)
1. Install the mount plate (C, Figure 18) on the bumper
using three bar clamps (G), six 3/8-16 x 2-1/2 bolts
(F) and 3/8-16 nylon lock nuts (H). Make sure the
top right bolts (circled) are on the outside of the verti-
cal bumper tube. Push the mount towards the left
until the top right bolts rest against the vertical
bumper tube and tighten securely.
C
H
H
H
F
F
F
G
G
G
2-Bag Hood & Mount Installation
A
B
I
B
I
I
B
B