16
00
Figure 24. Install Deflector & Hose
E
A
D
C
Install Deflector & Hose
1. Install the deflector (A, Figure 24) and hose adapter
(D) , with the tube pointing down, to the back plate
and secure with four 5/16-18 x 1” bolts (E), 5/16”
washers (C) and 5/16-18 nylon lock nuts (B).
2. Before installing the hose, measure the length of the
hose. This should be 55” (139cm) long. If not, cut to
length.
Note: When cutting the hose, it is necessary to cut
across the band of the hose. The easiest method for
cutting the hose is to use a utility knife to cut the clear
section of the hose and use wire cutter or tin snips to cut
the band. Before cutting, note the decal on the inside of
the hose noting the blower end. CUT THE OPPOSITE
END.
3. Insert the hose (G) over the hose adapter (D) on the
back plate and overlap by at least two bands.
Secure in place with the upper hose clamp (F) as
shown.
4. Insert the lower end of the hose over the blower
exhaust port and overlap by at least two bands.
Make sure the blower end decal is pointing towards
the blower exhaust port. Secure in place with the
lower hose clamp (H) as shown by hand-tightening
the knob..
5. Remove the valve stem covers and increase the rear
drive tire air pressure to 22 psi (151kPa). Reinstall
the valve stem covers.
A.
Deflector
B.
Nylon Lock Nut, 5/16-18
C.
Washer, 5/16”
D.
Hose Adapter
E.
Bolt, 5/16-18 x 1
F.
Upper Hose Clamp
G.
Hose, 55” Long
H.
Lower Hose Clamp
B
F
G
H
3-Bag Hood & Mount Installation
Содержание 46764
Страница 2: ...THIS PAGE INTENTIONALLY BLANK ...