Ferris 46764, Руководство оператора

Страница: 26 / 34

20
04
E-Z Dump Box & Mount Installation
Install Inlet
1. Remove the four phillips head screws and inlet
clamps located around the inlet opening on the right
hand side of the box (see Figure 33).
2. Install the inlet from the inside of the box (see Figure
34). Make sure the inlet is perpendicular to the top
of the box. (When the box is installed on the
machine, the inlet will be pointing straight down.)
3. Reinstall the screws and inlet clamps and tighten to
secure the inlet.
Figure 33. Inlet Clamp & Screw Location
(viewed from inside of box)
A.
Clamps & Screws
Figure 34. Inlet Installation
A. Inlet
A
A
A
Rotate Air Filter
(For units equipped with remote air filters)
1. Remove the end cap (A, Figure 35) from the air filter
housing.
2. Loosen the clamp (B) and rotate the air filter housing
forward until it reached the approximate position
shown in Figure 35. Tighten the clamp.
3. Reinstall the end cap (A) with the arrows pointing UP
as shown in Figure 35.
Figure 35. Rotate Air Filter
A. End Cap
B. Clamp
A
B