Ferno POWER X SN-POW1001, Руководство пользователя

Страница: 36 / 50

FERNO/MAN/0721/216-R22/UK
36
7.9 - Detaching harness straps from
trolley
The patient harness straps can be removed from the trolley for
cleaning or replacement.
Each strap is attached to the trolley frame by the use of a triangular
tang with a hole in it, which clips into a stud fixing, positioned in
various locations on the trolley, 2 on the rear of the backrest for
the shoulder straps, 2 on the side of the trolley near the backrest
pivot point and 2 each side for the leg straps.
To remove a strap from its fixing, place the palm of your hand on
the top of the tang and press down firmly. The tang will un-clip
from the fixing and the strap can be removed.
Press down on tang to remove strap
To attach a strap to its fixing put the fixing stud through the hole
in the tang and then lift firmly on the strap until the tang clips
into place.
Strap tang with fixing hole
7 - PREPARING TO TRANSPORT A PATIENT
Lift firmly until tang clicks in the stud
7.8 - Lateral transfer - chair to trolley
POWERX has been designed to minimise injury risk to patient
and operator by making the minimum trolley height as low as
possible.
As such, transferring a patient from chair to trolley and visa versa,
is made simpler, as the height differential between chair and
trolley mattress is minimised.
Lateral transfer from EZGlide to POWERX
Minimised manual handling when transferring patient
To help further minimise manual handling injury risks, it is
recommended to utilise any available manual handling aids
wherever possible, such as transfer boards, Beasytrans, etc. for
transfer of patient from chair to trolley.
With chair and trolley at similar height, this makes transfer from
chair and trolley minimal risk, as there is minimal incline when
moving the patient across the transfer board
Preparing to Transport a Patient