Fenix Imvico TK51 Series, Руководство по эксплуатации

Страница: 5 / 82

FENIX IMVICO
TK51/IF9000 OPERATION MANUAL
5/82
IMPORTANT NOTES ON TK51/IF9000 HANDLING
In order to preserve the life of the printer, it is necessary to keep in mind some
precautions in the handling of the TK51/IF9000. Please read carefully the
following points in order to make a good use of the printer.
SAFETY PRECAUTIONS
•
Before using the printer, read carefully section 2- INSTALLATION.
•
NEVER connect the external power supply with the wrong polarity. This could
permanently damage the printer.
•
Turn off the printer immediately if it produces smoke, a strange smell or an unusual
noise. Keeping on using the printer could cause fire. Unplug the equipment immediately
and contact your official distributor.
•
NEVER connect cables with different connectors from the ones mentioned in this
manual. Failing on doing so could permanently damage the printer.
•
Use a power supply whose output voltage is within the specification range stated in this
manual. Over voltage can permanently damage the printer. Under voltage can cause
malfunctions.
•
NEVER
wet TK51/IF9000 with water or any other liquid. If any liquid is spilled inside the
equipment, unplug the power cable immediately and contact the technical service.
•
Make sure the printer is on a steady, securely fixed surface. If the printer falls down, it
could break or damage.
•
NEVER use the printer in high humidity or in locations with high risk of fire.
•
NEVER place heavy objects on top of the printer and never lean on it.
•
NEVER put any object inside of the printer, as it could cause hardware damage on it,
such as short-circuit, print head breaking or general failure of the printer.
•
NEVER shake the TK51/IF9000.
•
NEVER disassemble or modify the hardware of the TK51/IF9000.
•
NEVER try to repair the TK51/IF9000. Please contact your official distributor in case of
failure.
•
As the printer contains electromagnets (inside of the motor), it should not be used in
excessively dirty environments or places with dust or metal particles.
•
NEVER print without paper loaded or without the cover closed, as the thermal print head
life can be highly shortened.
•
Avoid touching accessible parts with metallic objects, such as screwdrivers or tweezers,
the print head thermal elements as well as the electronic printed circuit. They are
delicate parts.
•
NEVER touch with your hands the areas around the print head and the motor surface as
they become very hot during and just after printing; wait 15 seconds after printing to let
them cool down.
•
NEVER touch the surfaces of the print head thermal elements or the electronic printed
circuit, as dust and dirt can stick to their surface and cause damage by electrostatic
discharge. Moreover, some electronic components can get very hot during operation.
•
The thermal paper contains Na+, K+ and Cl- ions that can cause harm to the print head
elements. Therefore, use only the specified paper.
•
If the printer has not been used for long period of time and the paper was loaded, the
paper could become deformed by the drive roller pressure. It is recommended to make it
advance at least 30 mm before printing again.
•
For safety reasons, unplug the printer if it is not going to be used over a long period of
time.
•
Do not print continuously (without stopping) for more than 6 minutes.