64
!
!
Planer-Thicknesser
A 941 / AD 941 / AD 951
Attention! Risk of material damage!
To obtain perfect working results it is necessary to strictly observe the manual guidelines and maintenance
instructions!
Attention! Risk of material damage!
Only use genuine Felder-Group carbide inserts due to their specific geometry. Due to safety reasons only use
genuine Felder-Group clamping screws for carbide inserts.
11.7.1 Safety instructions
• Only change the carbide inserts if the main switch of
the machine is on off.
• Only use genuine Felder-Group carbide inserts. Only
use genuine Felder-Group clamping screws. (see:
spare parts list)
• Only use the cutterblock with the appropriate safety
equipment. This applies particularly to the planer
guard.
• The tightening torque of the clamping screws has
to be in the specified torque range and should
neither be below nor exceed this range. It is strongly
recommended to use a torque wrench. Check the
correct setting of the torque wrench before each use.
(see: spare parts list)
• The use of a motorized or pneumatically powered
screwdriver to screw the inserts is not allowed!
• Check whether ALL screws are tightened correctly
before switching on the machine.
• The operation of the silent power cutterblock is only
allowed if ALL pockets are equipped with carbide
inserts.
• Check the carbide inserts and clamping screws for
damages with each change. If any damage occurs,
it is strictly forbidden to use the carbide inserts or
clamping screws.
• Check the threads of the pockets for damage and
ease of glide with each change. The machine may not
be switched on if the threads do not glide easily or the
required torque is not achieved.
• Ensure that the carbide inserts are aligned correctly
and are placed into the pocket at the correct angle
prior to tightening the clamping screw.
• Examine the pockets of the cutterblock for damages
when changing the carbide inserts.
• If there are any damages of the pockets recognisable,
the machine must not be switched on. Damaged
pockets may lead to the carbide inserts breaking!
• It is not authorised to use spanner-extensions to tighten
the carbide insert clamping screws. It is not authorised
to tighten the insert clamping screws using a hammer
for beating.
Note:
The silent power cutterblock is a high precision tool for woodworking.
This cutterblock was designed in conformity with the standard EN 847-1.
BG Test certified - Inspection n°: 139-063
US Pat. No. 7,708,038 and other patents pending
11.7 Cutterblock - Silent Power®
Faults
Содержание AD 941
