Felder AD 941, Руководство по эксплуатации

Страница: 11 / 72

11
Planer-Thicknesser
A 941 / AD 941 / AD 951
Surface planer and thickness planer unit:
• Risk of injury if come in contact with the rotating
cutterblock (Drilling tool).
• Danger of injury due to ejected workpieces and tool bits..
• Never reach into the infeed or outfeed side while the machine is running (during machining or idling)!
General safety rules:
•
Be wary of sharp edges to avoid cutting yourself, in particular when changing the tooling.
• Risk of injury due to ejected work pieces and parts of work pieces (e.g. branches, chips).
• Risk of injury from workpiece kickback.
• Hearing damage as a result of high noise levels.
•
Risk of damage to health from dust especially when working hard woods.
• Risk of injury through being crushed, cut, caught, wound up or sliced.
2.9 Other risks
Warning! Risk of injury!
Even if the safety measures are complied with, there are still certain associated risks that must be considered
when working on the machine:
Warning! Risk of injury!
In the event of a power supply failure, the electric brake is deactivated. The tool can therefore not come to a
complete stop within 10 seconds.
In this case, the machine will stop without using the the automatic braking system!
Safety
2.10 Particle emission
The working areas of this machine comply to DGUV
Information 209-044 and are classed as dust reduced.
The maximum concentration level of 2 mg/m³ of inhala-
ble dust in the air will not be exceeded.
This only applies if the conditions that are specified in
the section >Extraction< are adhered to.
See chapter entitled >Setup and installation<