OBID
®
classic-pro
Manual
ID CPR30.xx
FEIG ELECTRONIC GmbH
Page 27 of 126
H01114-0e-ID-B.docx
NOTICE:
The value of ISO14443 STUPT must be considered for calculating the TR-
RESPONSE-TIME (see CFG1)
ISO14443 FTUR:
In this parameter byte are some special features combined.
Bit:
7
6
5
4
3
2
1
0
Function
UID-
ORDER
OPTI
ERROR_RETRY
PLIC
BSLCT
BSLCT
(only
ISO 14443B Transponder)
This bit selects the response behavior for ISO 14443B Transponder with Bit-Rates
above 106 kBit / s.
The Reader principally use 106 kBit / for the first communication cycle. If the
Transponder supports a higher Bit-Rate and this is configured by the parameter
ISO14443 BIT RATE the Reader selects the highest possible Bit-Rate.
Unfortunately the reception from the Transponder could be on 106 kBit / s ore on
the new higher Bit-Rate.
b0:
The first reception after a Bit-Rate change is expected with 106 kBit / s.
b1:
The first reception after a Bit-Rate change is expected with the selected
higher Bit-Rate.
PLIC
(only ISO 14443-4 Transponder)
This bit enables the power level indicator check function of the Reader.
b0:
Power level check is disabled.
b1:
Power level check is enabled.
The power level indicator of ISO 14443-4 Transponders will be interpreted
by the Reader if it is supported by the Transponder.
If a Transponder response indicates insufficient power the Reader breaks
the present command and sends an error status.
ERROR_RETRY
(only ISO 14443-4 Transponder)
This parameter defines the maximum number of automatic retry loops in case of
transmission or protocol errors as described in ISO 14443-4.
b00:
disables retry loop
b01:
1 retry loop
b10
2 retry loops
b11:
3 retry loops