![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ss2000-plus/ss2000-plus_installation-and-operation-manual_3827536009.webp)
9
General Description
Installation and Operation Manual
General Description
Introduction
This manual describes the features, specifications, installation, and how to use the
encoder.
The encoder monitors and controls your siren system. The supports
one-way communication with the option of two-way communications using DTMF
or FSK encoding. Command sequences are programmable and stored in non-volatile
memory chips for retention, even when electrical power is disrupted.
For the most advanced systems, connect the to a PC running Federal Signal’s
Commander software. Commander and the can work together to monitor and
control your system, with the providing full redundancy in the event that your
PC is off line. Configure the using the S software program.
Features
• Streams Wave files from PC
• Compatible with SE3000 Encoder Software and Commander Software
• Printer port for standalone operation
• Can send printer messages to serial printer
• Two serial ports: one for control and one for extra peripheral devices or control
• Multiple codes/functions stackable under each button including Relay Outputs
• Two-Tone, MSK Packet Digital, EAS and DTMF encode
• FLASH/Programming Port
• Twenty-four activation buttons on front panel
• I
2
C port for external relays or keyboard for additional activation buttons
• Twenty optically isolated remote activation inputs built in (activated by dry contact
closure)
• Status LEDs and LCD display
• Level Meter for Setting Receive Level
• Two Line Inputs for Transmission of External Audio Sources (3.5 mm)
• XLR Input for microphone, phantom power supply for amplified microphones
• External Mic Input VOX (which simulates push-to-talk through audio level)
• Three programmable Relay Outputs
• High or Low Impedance for radio interface
• Carrier Detect from Radio/Transceiver or VOX
• Selectable Carrier Detect Polarity