![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ss2000-plus/ss2000-plus_installation-and-operation-manual_3827536028.webp)
28
Using the S Software
Encoder/Decoder
General Parameters
The following shows the General Parameters group box of the General Configuration tab.
Field
Description
AutoReport Delay
Enter the number of seconds to wait after activating a function
before requesting a report. The range is 0 to 99 seconds.
Report Request Timeout
Enter the number of seconds to wait for a response from a
Report Request before trying again or moving onto another
site. The range is 1 to 30 seconds.
Report Request Attempts Enter the number of times to attempt a request for a Report
from a site. The range is 1 to 3.
Under Run Buffer
Enter the number of milliseconds of streaming VoIP data
the saves in reserve. This is used to provide
the with data to spare if the data is momentarily
interrupted.
Aux LED
• None—The relay does not respond to any of these
conditions. Use for Activation Codes.
• WatchDogPoll—activates when there has been no poll
request to this unit in 30 minutes.
• RTU Fault—activates when a RTU siren site reports a
fault.
Morse Code ID
Enter up to 10 characters.
Morse Code ID Interval
• Off—Morse Code is off.
• 15 Min—transmits Morse Code every 15 minutes.
• 30 Min—transmits Morse Code every 30 minutes.
Use Attached Printer
Check to use printer with the