![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ss2000-plus/ss2000-plus_installation-and-operation-manual_3827536027.webp)
27
Using the S Software
Installation and Operation Manual
Descriptions of Functions Reported by RTUs–Sent to Printer
When a site is polled, it reports back the last function number that was run. This is where
the name and description for the functions are entered. These names and descriptions are
sent to the printer when the site reports back.
The following shows the Descriptions of Functions Reported by RTUs–Sent to Printer
group box of the General Configuration tab.
Field
Description
Spin box—Function #
Selects the function number.
Function Name
Enter the name.
Function Description
Enter the description.
Comm Port Parameters
The following shows the Comm Port Parameters group box of the General Configuration
tab.
Field
Description
Com Port 1 Baud Rate
Click the baud rate for com port number 1, which is the
Commander Software com port.
Com Port 2 Baud Rate
Sends the baud rate for com port number 2, which is the
accessory com port.
Com 2 Function
Click one of the following:
• None—Not used.
• Text Message— sends text messages from
Commander Software to an attached display sign.
• Printer Message— sends the messages that are
sent to the printer to a serial printer on com port #2.
• Control—com 2 is used as a control port to Commander
Software.
• Radio Mode— sends and receives Federal Signal
Digital traffic over the radio interface and com port 2.