![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ss2000-plus/ss2000-plus_installation-and-operation-manual_3827536038.webp)
38
Using the S Software
Encoder/Decoder
Uploading INI File to the
To upload the INI configuration file to the using SSLoader software, do the
following:
1. Click the Send Ini File to SS2000 button to upload a file to the . The
following warning appears.
2. Click OK. The SSLoader sends the INI file to the . The following dialog
box appears.
Connecting the Transceiver Interface
Unbalanced Interface (TB2)
To connect an unbalanced interface, do the following:
1. Connect the PTT relay COM output (TB2 pin 1) to TB10 - Ground.
2. Connect the PTT relay N.O. output (TB2 pin 2) to the transceiver and PTT input.
3. Connect the Carrier detect ground (TB2 pin 10) to the transceiver’s ground.
4. Connect the Carrier detect (TB2 pin 9) to the transceiver’s carrier detect output.
Jumper the unit to accept either active low or active high carrier detect. If the carrier
detect is not available, jumper the unit for VOX.
5. If other equipment is using this transceiver, connect its transmit audio to TB2 pin 4.
When the is transmitting, it interrupts this TX audio.
6. Connect the Transmit audio Hi output (TB2 pin 5) to the transceiver’s transmit audio
input.
7. Connect the Transmit audio Low (TB2 pin 6) to TB10 - Ground.
8. Connect the Receive audio input Hi (TB2 pin 7) to the transceiver’s receive audio
output.
9. Connect the Receive audio Low (TB2 pin 8) to TB10 - Ground.