![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ss2000-plus/ss2000-plus_installation-and-operation-manual_3827536043.webp)
43
Using the S Software
Installation and Operation Manual
Configuring the for operation over Ethernet
The needs to be configured for the following:
• Use the following IP Address (ObtainIPAddress=manual).
• IP Address is set to a Static address set aside for the .
• Subnet Mask is set for whatever is used for the network the is on.
• Default Gateway is set for whatever is used for the network the is on.
Setting Up a Virtual Com Port on a PC
Communicating with the over an Ethernet connection requires installing the
virtual com port drivers on the PC that is to be used.
To install the virtual com port drivers, do the following:
1. Open the folder for the appropriate OS in the RealPort driver folder.
2. Run the Setup.exe
The following dialog box appears.
3. Make sure the is on and plugged into the network for at least 1 minute and
that you have configured the Static IP Address of the .
If the is on the same network as the PC/PCs that are to use it, do the
following:
4. Click Next.