![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ss2000-plus/ss2000-plus_installation-and-operation-manual_3827536026.webp)
26
Using the S Software
Encoder/Decoder
Field
Description
128 Bit Encryption radio button
Enter your Encryption key to secure your .
The default Encryption key is all zeros.
256 Bit Encryption radio button
Enter your Encryption key to secure your .
The default Encryption key is all zeros.
Security Code
By default, the security code is 65535, which means
that the security code is open.
Unit ID#
Enter the unit ID number. Possible selections range
from 900 to 999.
Repeat All-Calls
Sets the to send all All-Calls commands
three times.
Spin box—Site #
Selects the RTU (siren site number).
Site Active
Check if the unit is active.
Repeaters Scheme #1
Enter in repeater numbers if used for this site.
The attempts to reach this site through
Repeater Scheme #1, if entered. If that fails, the
attempts through Repeater Scheme #2.
NOTE: Enter for each site Site Active and repeater
schemes, if used.
Repeater Scheme #2
Enter in repeater numbers if used for this site.
DTMF Communications
The following shows the DTMF Communications group box of the General
Configuration tab.
Field
Description
Spin box—Site #
Selects the RTU (siren site number).
Site Active
Check if the unit is active.
DTMF Gap Time
Enter DTMF gap time ranging from 5 to 100 ms.
DTMF Digit Time
Enter Digit time ranging from 35 to 100 ms.