SETTINGS
CPU
Single core 2.0 GHz
PEQ 1-8
Minimum system requirements for running DLM 260/480 so ware:
Storage space
1 GB
Opera ng system
Microso Windows
Running memory
2 GB
Need Microso Net framework 4 or higher and Microso Visual C++2015-
2022
The DLM series provided 3 kinds of control interfaces, namely USB, RS485,
TCP IP and there is no need to set up the connec on switching of the three
ways.
• Using a network cable to connect it is the most direct and safe way of
connec ng. Use a network cable to connect the PC's network port directly
to the processor's Ethernet port and make sure that the computer's IP is set
to automa cally get connec on (DHCP).
In order to get things working follow this ac ons sequence: Se ngs---
Network and Internet---Ethernet---Change adapter op ons---Select the
currently used adapter---Proper es---Internet Protocol version 4
(TCP/IPv4)---Select automa c get IP address.
CONNECTING TO A DEVICE
• Use RS485 protocol connec on through USB to RS485 device, you can
get the serial port of RJ45 port and connect directly to RS485-IN/OUT on
the rear panel. The RS485 input and output on the rear panel are designed
with loop-out design. When only one device is connected can be plugged
into RS485-IN/OUT at will.
A er the network cable connec on is confirmed, double click the DLM
series so ware, the device will be automa cally discovered and a pop-up
window will prompt.
When using the USB interface to connect, you need to pay a en on to the
following points:
- When your PC opera ng system is Windows XP or Windows 7, you need
to install the STM32 virtual COM driver so that the processor can be
correctly iden fied and connected.
- When your PC opera ng system is Windows 8 or above, there is usually
no need to install a driver and the system will correctly iden fy the
processor ( if the driver is not installed automa cally , install the STM32
virtual COM driver manually).
20
