SOFTWARE
In example, use the processor A channel input, the output channel 1 is
connected to a 2 way passive speaker and the route is a shown in the above
figure. The output channel uses a DLM Linear phase filter to perform a
virtual X-over on the speaker (it is be er to know the crossover point), so
that different compressor ac va on thresholds can be set for the high and
low drivers and, at the same me, this se ng will not destroy the original
amplitude and phase of the speaker can add some color or an extra
protec on as required.
The channel level page displays the input post-A/D and output pre-D/A
signal levels of all channelsa, corresponding to the physical level meter on
the front panel, where you can intui vely adjust the channel level and mute.
A new func on called "keep linked CHs level offset" has been added. The
conven onal linkage channel will link the level faders together. For some
ac ve speakers the output level ra o should remain the same. When this
happens select "keep linked CHs level offset".
The specific method is to assume that the output channels need to be
linked. When the output channel linkage is turned on, turn on the "keep
linked CHs level offset" at the red circle, so that the output channel can be
linked while maintaining the original ra o.
34
