CONNECTIONS
CONNECT WITH USB
When using the USB interface, directly connect to the USB port of the PC
with a B-type cable , add USB to the so ware and select the corresponding
model.
When using the network interface to connect use a category 5/6 network
cable to connect the Ethernet port of the processor to the network adapter
interface of the PC, adjust the IPV4 address op on of the corresponding
network adapter in the Windows network se ngs to automa cally obtain
DHCP and then open the so ware, the current processor can be found
automa cally.
USE NETWORK CABLE TO CONNECT
CAT5/6 Cable
The PC does not need to change the se ngs by default, directly connect
the Ethernet port of the PC and the processor with a network cable and
open the so ware in the CD to automa cally connect.
When using only one processor you can use DHCP to connect to the
processor. The specific methods are as follow:
When using mul ple processors you can use a fixed IP to reduce the error
rate. You need to set the PC to the same network segment as the processor
but different IP addresses.
1
2
1
2
22
