Fayat Group Dynapac CP2100, Инструкция по эксплуатации

Страница: 97 / 130

Maintenance - Every 10 hours
2020-01-06 4812314580EN 91
Check the brakes oil level
Check daily if the oil level is within the max. and min. marks.
Open the brake oil tank (1) under the plastic cap, on the right
side of the steering column.
Next, fill with hydraulic oil up to the tank's maximum level, if it
is under the min. mark.
Clean the coarse filter
The coarse filter is inside the frame' upper compartment, on
the right side of the machine.
To clean the coarse filter (1), open the drain cock (2) of the
filter and let the dirt run out.
If necessary, close the cock (3) and clean the filter and its
housing. Check if the rubber gasket of the filter housing is in
intact.
After the cleaning and inspection, put again all the
components on their right places and start the system to check
if it works correctly.
Another drain cock (5) is under the water tank, on the left side
of the front of the frame. It can be used to drain the water tank
and the pumping system.
It is also possible to install an extra pump if the standard fails
to work.
To drain the complete sprinkler system, refer to "Draining the
sprinkler system", in the section "Maintenance - Every 2,000
hours".
1
2
3
4
5
Fig. – Pump system, front frame, right side
1. Coarse filter
2. Drain cock
3. Cock
4. Water pump
5. Extra cock
Fig. - Brakes oil tank
1. Oil tank
2. Filling plug
1
2