Fayat Group Dynapac CP2100, Инструкция по эксплуатации

Страница: 123 / 130

Special instructions
2020-01-06 4812314580EN 117
Special instructions
Standard oil and fluid
recommended
When the roller leaves the plant, its several
systems are filled with oil or fluid indicated on
the item "Symbols and Lubricants", which are
proper for operating in places with
temperatures between 5 F and 104 F (-15°C
and 40°C).
The following recommendations are applied for
operations in places with temperatures up to
104 F (40°C).
Highest temperature,
from 122F (50°C).
The engine can work under this temperature
using standard production oil, but for other
components, use the following oils:
Hydraulic system - mineral oil, Shell Tellus
T100 or equivalent.
Lowest temperature -
risk of freezing
To prevent the system freezing, make sure
that the system has been drained (sprinkler
system, tank(s), hoses) or that antifreezing
solutions were applied.
Temperatures
The limit temperatures are valid for series
rollers.
The rollers with additional equipment, like
noise level diminution equipment may need
special attention when they are operated in
high temperatures.
High pressure
washing
It is important to keep in mind that the
high pressure water must not be
directed towards the fuel tank caps and
the hydraulic system.
Cover the filling nozzle caps with plastic and
lock them with rubber bands. It prevents the
water to penetrate into the cap vent hole,
which may cause damage on the involved
systems and obstructions in the filters.
Never direct the high pressure water towards
electric and electronic components or on the
display (always keep them covered by covers
or plastic).
Fire extinguisher
If there is fire on the equipment, use a dry fire
extinguisher or ABC class carbon dioxide. It is
also possible to use a CO
2
extinguisher (BE
class).
Roll Over Protective
Structure (ROPS)
NEVER weld or make holes on the ROPS.
NEVER repair a ROPS. Always replace it for a
new one.