Fayat Group Dynapac CP2100, Инструкция по эксплуатации

Страница: 100 / 130

Maintenance - Every 50 hours
94 4812314580EN 2020-01-06
Replace the Diesel engine oil filter
Never perform any maintenance work under the
machine while the engine is still operating. Always
park the roller on a flat and safe place and chock the
tires.
The oil filter (1) is on the right side of the engine compartment.
Refer to the Engine Instructions Manual to obtain information
about the oil filter replacement.
Check and replace the main air filter
Replace the main filter element when the
corresponding warning light on the instrument
panel comes on and the engine is in the maximum
speed.
1. Release the clamps (1), take off the cap (2) and the main
filter (3). Do not take off the backup filter (4).
2. If necessary, clean the air filter, according to this page
instructions.
3. When replacing the main filter (3), put a new one in its
place and fit back all the air filter components in the reverse
order.
4. Check if the dust valve (6) is in good conditions and
replace it, if necessary.
5. When fitting the cap, make sure the dust valve is positioned
downwards.
To clean the air filter, follow the instructions below:
1. Wipe inside the cap and the filter housing.
2. Wipe also both outlet pipe surfaces, as shown in figure.
Check if the hoses clamps between the filter housing
and the intake hose are tighten and if the hoses are
intact. Check the entire hose system, all the way to
the engine.
Fig. – Air filter
1. Clamps
2. Locking hook
3. Main filter
4. Backup filter
5. Filter housing
6. Dust valve
Fig.
Inside the
Outside the
outlet pipe outlet pipe
2
3
5
4
1
6
Fig. – Engine compartment
1. Oil filter
1