Fastech Ezi-Step II Plus-E, Руководство пользователя

Страница: 51 / 68

www.fastech.co.kr
51
Parameter
35 Jog Speed5 [pps] 1 500,000 5,000
36 Jog Speed6 [pps] 1 500,000 5,000
37 Jog Speed7 [pps] 1 500,000 5,000
38 Use Motion Queue 0 1 0
39 Disconnection Option 0 4 0
40 Communication Timeout msec 100 60,000 100
41 Motion Profile 0 1 0
42 ORG RET OK OFF OPTION 0 3 0
*1 In the case of drive for 86[mm] motor, this parameter not be used.
*2 The range of parameter 9, 10, 19, 20 differs from the product version, listed as below.
V06.01. 2 x.xx : -134,217,728 ~134,217,727
V06.01. 3 x.xx : - 2,147,483,648 ~ 2,147,483,647

Parameter No.30~40 are available from Firmware [ver.6.1.20.16].

Parameter No.41 and 42 are available from Firmware [ver.6.1.xx.19].
Parameter Description １０－２．
No. Description Unit
Lower
Limit
Upper
Limit
Default
0
Pulse per Revolution :
It means number of pulses per revolution.
If this value is changed, the motor is set to STEP OFF..

Pulse per revolution is not changed when the input signal
is 'Step On'.
Value Pulse/Revolution Value Pulse/Revolution
0 500 8 10,000
1 1,000 9 8,000
2 1,600 10 10,000
3 2,000 11 20,000
4 3,600 12 25,000
5 5,000 13 36,000
6 6,400 14 40,000
7 7,200 15 50,000
0 15 10
1
Axis Max Speed :
When position moving commands (absolute move, incremental
move) are given, this mode sets the maximum speed which the
motor can operate. So, the motor cannot be operated faster than
this value in any case. This value is set to [pps] unit.
Upper Limit value has limited by
Pulse per resolution value
*In case of 10000 : 500,000
In case of 20000 : 1,000,000
pps 1 500,000 500,000
2
Axis Start Speed :
When position moving commands (absolute move, incremental
move) are given, this mode sets the operation start speed to [pps]
unit.
pps 1 35,000 1