Fastech Ezi-Step II Plus-E, Руководство пользователя

Страница: 41 / 68

www.fastech.co.kr
41
Operation
①
To use DLL program or control input signal corresponding to ‘Stop’ and ‘E-Stop’. In this
case, operation is completely finished and is not connected to next operation.
②
The user can click 「Pause」 at User Program(GUI) to temporarily stop operating. In this
case, click 「Pause」 again, and remaining operation will be executed again.
Position control Operation
To operate the motor by parameters set by User Program(GUI) or DLL program. (This is not
connected with PT operation.)
Once position control operation is started, PT operation command is overridden. Likewise,
while PT operation is executing, position control operation command is overridden.
The followings show parameters applied to position control operation. All position table item
values are overridden.
Parameter Name
Setting Content Range
Axis Max Speed Operation speed after acceleration is finished 1~500,000[pps]
Axis Start Speed Operation start speed before acceleration starts 1~35,000[pps]
Axis Acc Time
Required time until the motor reaches the axis max
speed from stop status
1~9,999[ms]
Axis Dec Time
Required time until the motor reaches from the axis
max speed to the stop status
1~9,999[ms]
Motion Dir To select motion direction (CW or CCW) 0~1
Pulse per
Revolution
Number of pulses per revolution.
The range of ‘Axis Max Speed’parameter is depend
on this value.
0~15
Teaching Function
Teaching can be executed only by User Program(GUI). For more information, refer to 「User
Manual – Position Table Function」.