Fastech Ezi-Step II Plus-E, Руководство пользователя

Страница: 40 / 68

www.fastech.co.kr
Operation
40
Operation ７．
Power Supply Timing ７－１．
The power supply of Ezi-STEPⅡ Plus-E is supplied to the motor through the drive module.
Therefore, before supplying power, connect the cable between the drive and the motor, and
then supply power to the drive module.
The default setting of Ezi-STEPⅡ Plus-E after power supply is STEP OFF.
STEP ON Operation ７－２．
After power is supplied, set the drive module to STEP ON as follows.

Click ‘STEP OFF’ button at the User Program (GUI).

Give the drive a command through DLL library.

Assign ‘STEP ON’ to control input pin, and supply the drive with signal through the p
in.
Operation Mode ７－３．
This controller can do three control operations such as I/O command, communication command
(DLL program), and User Program (GUI)
(1) I/O Command Mode
This controller can execute control operation like in-position by I/O command transmitted
from the upper controller. The in-position control operation is executed by operating position
table with I/O command.
(2) Communication Command Mode
This controller can execute control operation like in-position by command transmitted from
the upper controller. The in-position control operation is executed by operating position table
with I/O command
Position Table Operation Sequence
It is can executed continuous operation by position table at the I/O command mode.
① By using PT A0 ~ PT A7 input signal or DLL program, set PT number to be operated.
② In case of STEP OFF, set the controller to STEP ON by communication program or STEP
ON control input.
③ Start to operate by rising edge of PT Start input signal or communication program.
Stopping Continuous Operation of Position Table
When the motor is executing continuous operation of position table with Ezi-STEPⅡ Plus-E,
stop executing position table by following methods.
If the ‘STEP ON’ signal is assigned to input pin, STEP ON command from GUI or
DLL library will not executed.
Caution