Fastcorp DIVI, Руководство по установке и эксплуатации

Страница: 21 / 62

Fastcorp, LLC
DIVI Setup and Users Guide
Page 21 of 62
Rev 6
22. VAC - Error Log:
An error history can be accessed by pressing the VAC button on the Service Keypad. Up to ten
errors are stored in the Error Log with a time and date stamp. Entries may be viewed in reverse
order of occurrence by pressing the “VAC” key. Each time the “VAC” key is pressed, the log will
scroll back one entry. Press “*” to exit.
23. PRODUCT DISPLAY SYSTEM

Determine what products will be vended and what the sale price will be.

Locate the Product Card Pack and the Price Sticker Sheets from inside the delivery bin.

Locate the Display Cards that correspond with the products that will be vended from the machine.

Locate the Price Stickers that will correspond with each product.

Access the Display Card Holder by sliding it up and out of the light housing.
o
Install the Price Stickers and then the Display Cards in the appropriate positions and on the
display card holder.
o
Slide the display card holder in front of the light housing when done.
24. BIN SETUP/ PLAN-O-GRAM
The DIVI Vendor utilizes a bin system to hold product. The bin system is made up of a number of bins of various shapes and
sizes. The type and size of the bins depends on the size and shape of the products being vended. Every machine comes
preconfigured with a specific bin layout or bin plan-o-gram. The configuration of the bin plan-o-gram inside your machine
may be modified to accommodate different size bins as your product line changes. If you have any questions relating to
modifying your plan-o-gram contact the Fastcorp Service Department.
Product Loading:

Press “LOAD” on the Service Keypad. The Freezer Lid will open and the Robot Arm will move to the rear cabinet
loading position. Bins may be filled without being impeded by the Robot Arm.

Press “CLOSE” on the Service Keypad when bins have been filled. The Robot Arm will return to the
front delivery position and the Freezer Lid will close. The Health Timer will automatically be set to 75
minutes to allow the freezer to recover from any possible temperature loss due to loading.

“Load” then “Close” will signal the VMC that the machine has been filled. Load/Close will
automatically set a Health Sensor delay for 75 minutes.
Notes:
It is important to program the appropriate bins as short bins. Short and tall bin locations will vary based on the
specific freezer in your machine. Bin height dictates how far down the picker tip will travel to get product. The
short bins are shaded in Fig 1 below (IC plan-o-gram). If short bins are programmed as tall bins, the robot will
make contact with the bottom of the bins and attempt to pull them out, resulting in possible machine failure